|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-01-2009, 11:10 PM
|
#1 | ||
|
'06 Ford Territory Turbo
Join Date: Sep 2008
Location: Toowoomba.
Posts: 456
|
Hi All,
Around about three months ago, I purchased a High Series AU Series 1 Cluste to go into my stock AU Forte. I've been wanting to do the swap over myself, but can't work out how to remove the pins in the wire housing or connection piece. I was just wondering if there is a specific tool because I went to Oxley Spare Parts at Wacol and pulled out several connectors to try to remove the pins on so I wouldn't damage my own, but I haven't had any luck removing any of the pins. I've been quoted from a group in Toowoomba that it'll set me back about $325.00inc to do the swap over, and I would rather do it myself as it is mostly a simple thing to do (in theory). I've gone over this guide, but I still can't work out the safest way to remove the pins. Any help is greatly appreciated. |
||
|
|
|
11-01-2009, 10:46 AM
|
#2 | ||
|
FF.Com.Au Hardcore
Join Date: May 2006
Location: Perth, South
Posts: 3,064
|
a very small screwdriver may do the trick, i haven't seen the actual plugs so i'm not sure how much room is in them, but i'm going to assume they are just a small clip setup? the other option is to go to dick smith and get a pack of small terminals, then just cut the wire off a bit back from the cluster and join a small piece on to that and the new terminal and push that in
|
||
|
|
|
|
11-01-2009, 10:29 PM
|
#3 | ||
|
Walking with God
Join Date: Mar 2005
Location: Melbourne
Posts: 7,321
|
Try this reading also.
FULL ARTICLE ON CLUSTER CHANGES FROM FORDMODS http://fordmods.com/forums/documents.php?doc=4 Hope that helps. GK
__________________
2009 Mondeo Zetec TDCi - Moondust Silver 2015 Kia Sorento Platinum - Snow White Pearl 2001 Ducati Monster 900Sie - Red Now gone! 1999 AU1 Futura Wagon - Sparkling Burgundy On LPG Want a Full Life? John 10:10 |
||
|
|
|
Low Series Cluster Change to High Series Issues.
Linear Mode
