Welcome to the Australian Ford Forums forum.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact us.

Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated.

Go Back   Australian Ford Forums > Club and Speciality Forums > Forum Community Car Clubs > AU Falcon.com.au

Reply
 
Thread Tools Display Modes
Old 16-08-2011, 03:07 PM   #31
rowan194
FF.Com.Au Hardcore
 
Join Date: Jun 2005
Posts: 588
Default Re: Poked evaporator drain tube, now other side of engine is leaking something?

Turns out there wasn't a missing bolt, I just did the diagram wrong. It's all back together... finally.

There is one thing, after I'd been idling the engine about 4-5 mins I noticed some smoke (!) in the engine bay. I switched the engine off immediately. It seems to be coming from the same side of the engine as the plugs I replaced, so either from the plugs or gasket. I think it may be some stray sealant burning off?

There's definitely water in the engine, it's barely warm to the touch, and the temp gauge is below "normal"... so I don't think it's the engine overheating?

Still a bit unsure, it's a little disconcerting to see smoke wafting over your engine!
rowan194 is offline   Reply With Quote Multi-Quote with this Post
Old 16-08-2011, 04:38 PM   #32
rowan194
FF.Com.Au Hardcore
 
Join Date: Jun 2005
Posts: 588
Default Re: Poked evaporator drain tube, now other side of engine is leaking something?

Is it just the new exhaust manifold gasking burning in? It keeps smoking after I kill the engine, and it doesn't smell like exhaust.
rowan194 is offline   Reply With Quote Multi-Quote with this Post
Old 16-08-2011, 08:30 PM   #33
mik
FF.Com.Au Hardcore
 
mik's Avatar
 
Join Date: Feb 2005
Location: Melb north
Posts: 12,025
Default Re: Poked evaporator drain tube, now other side of engine is leaking something?

yep, it`s normal, after a little while it will burn off, keep an eye on your coolant level , it might take a while to bleed the air through, usually once the engine gets to operating temp the thermostat opens and the level goes down a tad, just keep an eye on the egg crate for a day or two, you should have the heater turned on hot when refilling coolant if you have`nt, if not it may take longer to bleed all the air out.
mik is offline   Reply With Quote Multi-Quote with this Post
Old 16-08-2011, 09:12 PM   #34
rowan194
FF.Com.Au Hardcore
 
Join Date: Jun 2005
Posts: 588
Default Re: Poked evaporator drain tube, now other side of engine is leaking something?

Smoke stopped once I'd done a couple of careful laps of the block.

There's just tap water in there for now, tomorrow I'll be using a radiator flush product then adding coolant + demineralised water. Maybe an extra fill + flush in the middle.

I have the climate control set on 32C, she cannae go any higher cap'n!
rowan194 is offline   Reply With Quote Multi-Quote with this Post
Reply


Forum Jump


All times are GMT +11. The time now is 08:36 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Other than what is legally copyrighted by the respective owners, this site is copyright www.fordforums.com.au
Positive SSL