|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-07-2007, 08:36 AM
|
#1 | ||
|
Starter Motor
Join Date: Jul 2007
Posts: 1
|
Hi all,
I have a KF Laser fitted with the 16V Carby 1.6 and Auto, (I believe is a B6-2E ??). The motor in it had punched a hole in the block so it needs replacing. A friend of mine had one sitting around so i planned to use this, except it only turns over half way and stops...Think it's slipped a bearing or ring (looked into it). Now I am looking at getting a 1.6 carby from an KC-KE (believe it is the B6??) and it comes with auto attached. But I would like to use my Auto if possible, Am I assuming right that both motors been a B6 that the block is the same and will bolt up?? The other thnig I would like to do is fit the 16Valve head of the KF motor If that will fit the older block Thanks heaps Dave |
||
|
|
|
05-07-2007, 10:04 PM
|
#2 | ||
|
Over Thinker
Join Date: Dec 2005
Location: Ipswich Qld
Posts: 1,351
|
have to wait for a laser guru on that one or ring the ford dealership /a wrecker ?
__________________
My car goes Brumm Brumm |
||
|
|
|
|
06-07-2007, 12:47 PM
|
#3 | ||
|
03 LR Focus / 90 KF TX3 T
Join Date: Jan 2005
Posts: 22
|
I'm pretty sure the bottom ends are the same, it's just the head that's different, but knowing Mazda I wouldn't be surprised if a bolt is moved 3mm to the left, or it's threaded the wrong way somewhere causing the whole thing to be useless.
Where abouts are you? I'll have a B6-2E pulled from my (running nicely) KH shortly (turbo BP conversion), but I'm in Adelaide |
||
|
|
|
B6 and B6-2E differences
Linear Mode
