|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
22-05-2008, 08:39 AM
|
#1 | ||
|
First time Falconless
Join Date: Oct 2006
Location: Brisvegas
Posts: 374
|
I installed a set of progressive king lows in my AUIII about 3 days ago. The rear has come down nicely about an inch or so, but the front has only dropped about 5mm from the factory height.
Does anyone know how long it takes these springs to settle? Has anyone else had the same thing happen? If so what are my options because I would like to see the front come down a little more? There is also a small rattle that I can now hear, since its been lowered, when the car is travelling at low speed, especially when turning a corner. It sounds like metallic tapping coming from the front end. Any ideas what this may be? Cheers |
||
|
|
|
22-05-2008, 08:46 AM
|
#2 | ||
|
Banned
Join Date: Jan 2005
Location: Beaumont Hills
Posts: 2,536
|
Front will come down in about 2 weeks or so.. give it a few hundred k's. Mine was the same, then settled another 10-15mm.
Not sure on the tapping sound from the front end.. |
||
|
|
|
|
22-05-2008, 08:54 AM
|
#3 | ||
|
First time Falconless
Join Date: Oct 2006
Location: Brisvegas
Posts: 374
|
Thanks for that. I have a feeling the tapping may be from a spring that is not properly seated on the rubber.
|
||
|
|
|
|
23-05-2008, 05:12 PM
|
#4 | ||
|
The Monty
Join Date: Oct 2007
Location: Geelong
Posts: 1,226
|
have u already had a new camber kit in it ?
|
||
|
|
|
|
23-05-2008, 06:32 PM
|
#5 | ||
|
First time Falconless
Join Date: Oct 2006
Location: Brisvegas
Posts: 374
|
No didn't use one. We just put some shims in behind the upper control arm.
|
||
|
|
|
|
23-05-2008, 07:46 PM
|
#6 | ||
|
FF.Com.Au Hardcore
Join Date: Sep 2007
Posts: 717
|
I had noise issues after lowering mine. Make sure everything is tightened properly. That was my issue.
|
||
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Lowered on king springs
Linear Mode
