Welcome to the Australian Ford Forums forum.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact us.

Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated.

Go Back   Australian Ford Forums > Club and Speciality Forums > Forum Community Car Clubs > AU Falcon.com.au

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 26-11-2006, 06:07 PM   #1
Hords
Treasure your balls?
 
Hords's Avatar
 
Join Date: Jul 2005
Location: NW Melbourne
Posts: 2,570
Default Sound Deadening AU Front Doors

G’day All,

I’m wondering if anyone out there has had experience in sound deadening AU Front Doors.

My main concerns are covering the inner door skin service holes before applying Dynamat. My intention was to use duct tape and MDF. However the problem with the service holes is that most of them aren’t on “flat” surfaces making it hard to cover using MDF. There is also a pouch on the door trim which protrudes into the inner panel once the trim is reattached. On top of this there are also several plastic alignment tabs which are also part of the trim. I was simply going to cut these off so their corresponding holes can be covered and sealed.

Also, what would be the best method to apply deadening to the outer door skin? Here I’m stumped about the anti-intrusion bar. Would it be practical to apply a sheet above and below the bar and then cover the bar with a small strip, or just cover the bar with some brush-on deadener? Or even don’t bother with it?

Any help on this subject would be greatly appreciated.

Cheers,
Rob

Hords is offline   Reply With Quote Multi-Quote with this Post
 


Forum Jump


All times are GMT +11. The time now is 01:00 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Other than what is legally copyrighted by the respective owners, this site is copyright www.fordforums.com.au
Positive SSL