|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
24-11-2007, 07:34 PM
|
#1 | ||
|
Falcon Unbelievable
Join Date: Oct 2007
Location: SE Melbourne
Posts: 261
|
Wats the easiest way to remove spot welding from the rear passanger 1/4 panel on an AU sedan?
|
||
|
|
|
24-11-2007, 08:03 PM
|
#2 | ||
|
FF.Com.Au Hardcore
Join Date: Nov 2005
Location: perth
Posts: 4,355
|
ither drill them out or chisswl them of
drilling is alot neater but your left with a hole to fill but ... if your replacing one of the panels you can place a strip behind or the new pannel behind and weld up the hole and grind back
__________________
yes still (as money n time permit) doing the rebuilding the zh fairlane with a clevo 400m 4v heads injected whipple blown with aode 4 speed trans to a 9" ....... we'll get there eventually just remember don't be afraid to try something new. Remember, amateurs built the Ark...Professionals built the Titanic! I have taken up meditation... at least it's better than sitting around doing nothing !! |
||
|
|
|
|
24-11-2007, 09:54 PM
|
#3 | ||
|
Falcon Unbelievable
Join Date: Oct 2007
Location: SE Melbourne
Posts: 261
|
Will it be hard to fit another rear 1/4 panel on?
|
||
|
|
|
|
24-11-2007, 10:01 PM
|
#4 | ||
|
FF.Com.Au Hardcore
Join Date: Nov 2005
Location: perth
Posts: 4,355
|
as hard as someone rebuiding a motor when theyve never done it before
and you need some more tools than just a drill and some spaners you need a mig and dont rush it , if you try to weld to much at once youll warp the panel
__________________
yes still (as money n time permit) doing the rebuilding the zh fairlane with a clevo 400m 4v heads injected whipple blown with aode 4 speed trans to a 9" ....... we'll get there eventually just remember don't be afraid to try something new. Remember, amateurs built the Ark...Professionals built the Titanic! I have taken up meditation... at least it's better than sitting around doing nothing !! |
||
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
how do you remove spot welding from the rear passanger 1/4 panel on an AU sedan?
Hybrid Mode