head gasket blown/head removal
|
|
head removal and timing belt info should be in amoung the posts in here if not I will make a how to do
elec spec valve adj and timing belt page 1
put timing on TDC num 1 cyl up on compression
do not turn engine over from this time until head is refitted
drain coolant
drain oil
undo rocker cover
undo cam belt cover and mark the belt and one cam tooth with nail polish
so you know where to refit the belt and the cam
undo cam gear and rockers
undo all wiring and hoses /fuel lines and mark vacuume lines from where they came
remove dissy
undo head bolts
remove head clean gasket surfaces and check for warpage
get head done by head reconditioner and a pressure test for cracks and a reface///get valves checked and new valve stem seals fitted
check block for warpage
fit new gasket torque to spec
fit new gaskets as required
reconnect everything fit dissy and timing belt to the same position as before
fill radiator and oil to engine
__________________
My car goes Brumm Brumm
Last edited by dirty hands; 25-01-2007 at 05:09 PM.
|